Get your stealth setup running in minutes. No messy cords, just a clean, professional finish.
1. Mount It
-
Clean: Wipe your windshield with alcohol.
-
Stick: Peel the film and press the mount firmly to the glass.
-
Adjust: Use the thumb-screw to level your detector.
3. Wire It Up
-
Ground: Bolt the Black Wire ring terminal to any bare metal chassis bolt.
-
Power: Connect the Copper Wire to a switched (accessory) circuit using a Fuse Tap (sold separately). This ensures the unit turns off with your car.
4. Plug & Play
-
Snap the magnetic connector into the top of the mount.
-
Tuck your wires into the headliner/trim.
-
Start your engine and stay protected.
Note: We recommend a Fuse Tap for the cleanest install. If you’re not comfortable with vehicle wiring, any local car audio shop can finish this in under 15 minutes!
If you need any help or have any questions. Please reach out to us